We'll see the components of the typical DeskTop SlimLine TTX Shuttle POPRC SB86i.

The development of the WTC specification computer has been carried out in compliance with two principles: to minimize the number of ventilations in the body and to use them most effectively. But for one fan to cool not only the processor, but also the hard drive and expansion fee, the system fee design and the hull have to be changed. They differ from the APC format components.

The thermal balance module contains only one fan that cools the processor radiator and the video card. Optical disk and cold extension charges are isolated from the main flow, they do not require additional cooling. Rigid disc, depending on the type of hull, may cool. nutrition unit or heat balance module.

Naturally, if the air flow is to pass effectively through all the components of the shell, it shall be located longitudinally to the base and preferably on the air path from other fans.

The TTX Corps only allows for low-value expansion fees, except for a graphic map that can be complete. It is positioned horizontally across the edge of the PCI-Express slot through a special transitional device (reiser).

The system fee is fixed by the rifles directly to the bottom of the chassis.

The design cooling device of the processor does not look like the heat exchanger in the APC hulls. Radiator is aluminium with flat ribs and a copper base.

The processor break LGA 775 will be at an angle of 45° to the fee itself. Thus, air flow under the radiator is detected on the end of the nest and is more effective on the surface of the system fee.

The processor nest is followed by chipset radiators, and DIMM slots, PCI-Express 16x and PCI 2.3 are placed in parallel so that the air can pass through them.

One DIMM module is cooler than the second, but the second one has a substantial part of the air flow, so the overheating of memory here will not be threatened.

The specification of the GTX is that the heat balance module is fixed immediately to the bottom of the shell.

The processor ventilator is assigned four rifles to the platform ' s hull through a system fee and ultimately takes most of the inside of the system unit.

There is only one ATA-100 unit on the system fee, which is also longitudinally located to avoid air flow. Four SATA-150 ports are installed, two of which are already connected.

In the computer under review, two expansions - PCI-Express 16x and PCI 2.3. It's not as usual in the left of the computer, it's in the right.